Lancia Lybra Owner's Handbook Manual page 187

GENERAL INSTRUCTIONS
– When a light is not working, check
that it has not fused before changing
the bulb.
– For the location of the fuses, refer to
"If a fuse blows" in this chapter.
– Before replacing a bulb that does
not work, check that the contacts are
not oxidised.
– Burnt-out bulbs must be replaced
with ones of the same type and power.
– Always check the slant of the head-
light beam after changing a bulb for
safety reasons.
IMPORTANT On the inside surface
of the headlight there could appear a
slight coat of fogging; this does not
show a defect, since it is a natural oc-
currence due to low temperature and
to the degree of humidity in the air; it
will soon disappear as soon as the
lights are turned on. The presence of
drops inside the headlight shows
water seepage, refer to the Lancia
Dealership.
186
TYPES OF BULBS
Several types of bulbs are installed in
the car (fig. 22):
A Glass bulbs
Snapped into position. Pull to
remove.
B Bayonet connection bulbs
Remove from the bulb holder by
pressing the bulb and rotating it
anti-clockwise.
C Cylindrical bulbs
Remove by pulling away from
terminals.
D - E Halogen bulbs
To remove the bulb, release the
clip holding the bulb in place.
fig. 22