Lancia Lybra Owner's Handbook Manual page 111

Buttons for adjusting
p
fan speed (6 - fig. 102)
Press the upper or lower button to
increase or decrease the fan speed, re-
spectively, so to adjust the amount of
air let into the passenger compart-
ment while keeping the required tem-
perature constant.
The fan speed is indicated by the
bars which light up on the display 8.
Repeatedly press the upper button to
switch the fan on at top speed (all
bars on). Repeatedly press the lower
button to switch off the fan (no bars
on).
IMPORTANT In versions with cool-
ing system (where fitted), the fan can
only be switched off when the climate
control system compressor is switched
off with the ECON button.
Press the AUTO button to restore
automatic fan speed control after a
manual setting.
110
Buttons for adjusting air
distribution (5 - fig. 102)
Press buttons 5 to manually select
one of the five possible air distribu-
tion patterns in the passenger com-
partment:
O
Air flow to central and side da-
shboard vents and the rear vent.
M
Air flow shared between foot-well
vents (warmer air) and central and
side dashboard vents and the rear
vent (cooler air).
This air distribution pattern is par-
ticularly useful in the middle seasons
(spring and autumn) when it is
sunny.
N
Air flow to the front and rear
footwells.
The air distribution pattern, due to
the natural tendency of heat to move
upwards, allows to heat the passenger
compartment up as fast as possible.
Furthermore, it offers a prompt feel-
ing of warmth to the coolest parts of
the body.
Q
Air flow shared between the
footwell vents and the windscreen and
front side window defrosting/demi-sting
vents.
This air distribution pattern ensures
a good heating of the passenger com-
partment and prevents possible mist-
ing up.
ü
Air flow to windscreen and front
side window vents for demisting or de-
frosting the windows.
IMPORTANT The system will not
accept different combinations. If an
air distribution pattern will cannot be
used is selected only the main func-
tion of the pressed button will be
started.
The set air distribution pattern is
shown on display 7.
When a combined function is set,
only the main function of the button
pressed will be switched on. If the
button corresponding to a function
which is already on is pressed, the
function will continue to work.