Location Requirements - KitchenAid Pro Line KHWV01RSS Technical Education

LOCATION REQUIREMENTS

Selecting the proper location for your washer
improves performance and minimizes noise
and possible washer "walk."
The washer can be installed under a custom
counter, in a basement, laundry room, closet, or
recessed area. See "Drain System," page 2-3.
IMPORTANT: Do not install or store the washer
where it will be exposed to the weather.
Companion appliance location requirements
should also be considered. Proper installation
is your responsibility.
You will need
• A water heater set to deliver 120°F (49°C)
water to the washer.
• A grounded electrical outlet located within
6 ft (1.8 m) of where the power cord is attached
to the back of the washer. See "Electrical
Requirements," page 2-4.
• Hot and cold water faucets located within
5 ft (1.5 m) of the hot and cold water fill
valves, and water pressure of 20-100 psi
(137.9-689.6 kPa).
• A level floor with a maximum slope of 1˝
(2.5 cm) under entire washer. Installing the
washer on carpeting is not recommended.
• A sturdy and solid floor to support the washer
with a total weight (washer, water and load) of
550 lbs (249 kg).
Do not operate your washer in temperatures
below 32°F (0°C). Some water can remain
in the washer and can cause damage in low
temperatures. See "Washer Care," page 3-20
for winterizing information.
Installation Spacing
The following spacing dimensions are recom-
mended for this washer. This washer has been
tested for installation with spacing of 0˝ (0 cm)
clearance on the sides, front, rear, and top.
Recommended spacing should be considered
for the following reasons:
• The location must be large enough to allow
the washer door to be fully opened.
• Additional spacing should be considered for
ease of installation and servicing.
• Additional clearances might be required for
wall, door, and floor moldings.
• Additional spacing of 1˝ (2.5 cm) on all sides
of the washer is recommended to reduce
noise transfer.
• Companion appliance spacing should also
be considered.
Washer Dimensions
57"
(144.8 cm)
*Includes the door handle.
**Includes the feet extended 1" (2.5 cm). The optional
decorative mat (included) will add approximately ¹⁄
NOTE: Door is not reversible.
Recommended installation spacing for
custom undercounter installation, washer
only
The dimensions shown are for a washer with-
out the optional decorative mat placed on top.
1" (2.5 cm )
42" min.
(106.7 cm)
1"
(2.5 cm)
2-2
33" (83.8 cm)*
27"
(68.6 cm)
1"
27"
(2.5 cm)
(68.6 cm)
42"
(106.7 cm)**
" (1.3 cm).
2