KitchenAid Pro Line KHWV01RSS Technical Education page 99

PROBLEM
DRUM WON'T
ROTATE
MOTOR
OVERHEATS
WON'T DRAIN
MACHINE VIBRATES
INCORRECT
WATER
TEMPERATURE
DISPLAY FLASHING
NOTE: Possible Cause/Tests must be performed in the sequence shown for
each problem.
1. Check drive belt.
2. Check drive motor.
3. Unplug washer or disconnect power.
4. Check wire harness connections.
5. Plug in washer or reconnect power.
6. Check the MCU by looking for operations of the drive motor.
1. Check drive motor.
2. Unplug washer or disconnect power.
3. Check wire harness connections.
4. Check drive belt.
5. Plug in washer or reconnect power.
6. Check the MCU by looking for operations of the drive motor.
1. Unplug washer or disconnect power.
2. Check wire harness connections.
3. Check drain pump.
4. Check drain pump motor.
5. Check that the drain hose and drain pump filter are clear of foreign objects.
6. Plug in washer or reconnect power.
7. Verify CCU operation by running a Diagnostic test or any cycle.
1. Remove shipping system.
2. Check installation.
3. Check leveling feet.
1. Check that the inlet hoses are connected properly.
2. Unplug washer or disconnect power.
3. Check the water heater and wire harness connections to it.
4. Check water temperature sensor for an abnormal condition (see "Water
Temperature Sensor").
5. Plug in washer or reconnect power.
6. Verify CCU operation by running a Diagnostic test or any cycle.
See "Failure/Error Display Codes."
POSSIBLE CAUSE/TEST
6-13