Removing The Airtrap - KitchenAid Pro Line KHWV01RSS Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Pull the washer away from the wall so that
you can access the rear panel.
4. Remove the thirteen screws from the
rear panel and remove the panel from the
washer.
Rear Panel Screw (1 of 13)

REMOVING THE AIRTRAP

4-20
5. Remove the T-20 hex-head screws from
the bottom brace and remove the brace.
Airtrap
6. Pull the pressure hose off the airtrap fit-
ting.
7. Remove the T-10 screw from the airtrap.
8. Press the locking arm to unlock the airtrap
and pull it back and off the tub. NOTE:
Replace the rubber o-ring if it is cracked
or worn.
Pressure Hose
Airtrap
Bottom Brace
Screw
Locking Arm