Removing The Drive Motor - KitchenAid Pro Line KHWV01RSS Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Pull the washer away from the wall so that
you can access the rear panel.
4. Remove the rear panel from the washer
(see page 4-20 for the procedure).
5. Remove the two T-20 hex-head screws from
the bottom brace and remove the brace.
Bottom Brace

REMOVING THE DRIVE MOTOR

Drive Motor
6. Remove the drive belt from the end of the
drive motor shaft and then remove the belt
from the drive pulley.
Drive Pulley
7. Disconnect the green ground wire from the
drive motor frame.
8. Remove the 1/2˝ hex-washer-head mount-
ing bolt from the drive motor.
Mounting Bolt
Ground Wire
Continued on the next page.
4-23
Belt
Drive Motor
Pivot Stud