Removing The Motor Control Unit - KitchenAid Pro Line KHWV01RSS Technical Education

REMOVING THE MOTOR CONTROL UNIT

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the toe panel (see page 4-5 for
the procedure).
Motor Control Unit
Wiring Access Door
4. Open the wiring access door on the front
of the motor control unit.
5. Disconnect the four wire connectors from
the motor control unit (see the photo at
the top of the right column). NOTE: Each
connector has a locking arm or locking
tabs that you must release to remove the
connector from the unit.
2-Wires
Grn/Yel
4-Wires
3-Wires
6. Cut the wire tie and pull the cut tie out of
the slot in the standoff. NOTE: Be careful
not to cut any of the wires in the tie.
7. Lift the locking tab on the motor control
unit, and slide the tabs forward as far as
they will go.
8. Lift the motor control unit so the tabs are
out of their chassis slots, and remove the
unit from the washer.
Continued on the next page.
4-15
Cut
Wire
Tie
Motor Control Unit
Lift Locking Tab