Door Lock/Switch Assembly - KitchenAid Pro Line KHWV01RSS Technical Education

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

DOOR LOCK/SWITCH ASSEMBLY

Door Switch Actuator
Pins 1 & 2
Pins1 - 3
Door Lock Switches
Refer to page 4-4 for the procedure for access-
ing the door lock/switch assembly.
1. Unplug washer or disconnect power.
2. Set the ohmmeter to the R X 1 scale.
3. To test the door switch:
a) Disconnect the connector from the
CCU.
b) Touch the ohmmeter test leads to the
two connector pins. The meter should
indicate as follows:
Door closed = 0 Ω.
Door open = infinite (open circuit).
2 1
(Connector Viewed From Wire End)
c) Reconnect the door switch connector
to the CCU.
WARNING
Electrical Shock Hazard
Pins 4 - 7
5-3
4. To test the door lock/unlock sole-
noids:
a) Disconnect the connector from the
CCU.
b) Touch the ohmmeter test leads to the
indicated connector pins. The meter
should indicate as follows:
Lock solenoid at pins 1 and 3 = 60 Ω.
Unlock solenoid at pins 2 and 3 = 60 Ω.
1 2 3
(Connector Viewed From Wire End)
c) Reconnect the door lock/unlock sole-
noid connector to the CCU.
5. To test the door lock main switches:
a) Turn the washer on and select a cy-
cle.
b) Press START and you should hear the
door lock solenoids engage.
c) Unplug the washer from the wall out-
let.
d) Disconnect the door lock main switch
connector from the CCU.
e) Touch the ohmmeter test leads to the
indicated connector pins. The meter
should indicate as follows:
Main switch 1 at pins 4 and 5 = 0 Ω.
Main switch 2 at pins 6 and 7 = 0 Ω.
45 67
(Connector Viewed From Wire End)