Removing The Central Control Unit - KitchenAid Pro Line KHWV01RSS Technical Education

REMOVING THE CENTRAL CONTROL UNIT

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the control as-
sembly (see page 4-2 for the procedures).
4. Remove all of the wire connectors from
the central control unit (see the photo at
the top of the right column). NOTE: Each
connector has a locking arm or locking
tabs that you must release to remove the
connector from the unit.
Central Control Unit
4-12
Serial
Door
Motor Control
Comm
Switch Flowmeter
Link
Temp.
Pressure
Sensor
Switch
5. Unlock the two wire clips and remove the
wires from each of the clips.
6. Pry up on the locking tabs with a small
screwdriver and unhook the central control
unit from the washer.
Heating
Element
Relay
Door Lock
Main
Switches
Unit
Disp.
Inlet Drain Door Lock
Sw/Mtr
Valves Pump Solenoids
Locking Tabs
Central Control Unit
Line
Filter