Table of Contents
Advertisement
Pan, Tilt, Zoom (PTZ)
Rev 1.00
This chapter describes how to set up PTZ control on the HRDV. Pan, Tilt, and Zoom
drivers are available to control:
•
Pelco® D PTZ cameras that support the Pelco D protocol
•
Kalatel® Cyberdome
•
VCL PTZ cameras
To set up PTZ control:
1.
Go to the Remote Access screen (MENU
2.
In the RS-485 Setup area of the screen, set the HRDV Address (1 to 249). Typically
this address is predetermined by a system plan.
3.
Set HRDV is Master when the HRDV is controlling the dome. Set HRDV is Slave if
an external controller (for example, a Quarterback) is controlling the dome.
4.
In the Baud Rate field, select a baud rate that is identical to the operational baud
rate of the PTZ camera.
5.
In the Dome Address field:
a.
Select a camera (1 to 16).
b.
Set the dome address (1 to 249). Typically, this address is predetermined by a
system plan.
c.
Select the desired protocol (Pelco D, Kalatel, VCL).
d.
Select other cameras and configure according to the operational requirements
of the camera.
➤
System Setup
155
21
➤
Remote Access).
Document 900.0261
04/05
Advertisement
Table of Contents
