Figure 17-5 Report Zone Layout Screen - Honeywell HDVR Reference Manual

Time
criteria
Field
Scan Timelapse
Scan Events
Scan All Data
Sensitivity
Camera
Trigger Size
Direction
?
Check Every
Occurences
Time criteria
Rev 1.00
Figure 17-5 Report Zone Layout Screen
The following table describes the fields on the Report Zone Layout screen.
Description
Searches all timelapse clips for the specified motion criteria.
Searches all event clips for the specified motion criteria.
Searches all video clips (timelapse and event) for the specified motion criteria.
Select the sensitivity of the motion detector:
High sensitivity will detect almost all motion but may yield too many results.
Low sensitivity will yield a manageable number of results but may miss the instance
you are looking for.
Select the video clips from a specific camera to be searched for motion.
Set the minimum size a moving object must be in order to be detected.
Set the direction(s) the motion must be moving to be detected. Options are:
Left, Right, Up, Down or any direction
Opens a small help window.
Set how often the report should check for motion.
Set the maximum number of instances to report and if reached, stop searching.
Set how many seconds before instance the beginning of each motion clip should
Start at, and how long it should Play for afterwards.
Set the Start and Stop time and date for the video to be searched for motion.
119
HRDV Reference Guide
Motion zone
layout grid
Document 900.0261
04/05