Setting Simple Timelapse Mode With Motion Detect Enabled - Honeywell HDVR Reference Manual

Setting Simple Timelapse Mode With Motion Detect Enabled

Rev 1.00
4. Enable cameras (MENU
Note Ensure that any cameras not being used are disabled to prevent alarms from
occurring.
5. Verify timelapse recording is occurring:
a. Exit Program mode.
b. Look for a dull red dot on the top right-hand corner of Monitor 1. This indicates
that timelapse recording is taking place.
6. View the current clip being recorded:
a. Press PLAY and enter your user name and password when prompted. Press
Enter.
b. Use the jog wheel controls to review the most recent clip.
For more extensive clip reports, see
Motion detect enabled causes the HRDV to only record timelapse clips of the individual
cameras that motion is detected. To set Simple Timelapse with motion detect:
1. Follow the procedure for Simple Timelapse above.
➤ ➤
System Setup Video Inputs).
Chapter 17, Report
65
HRDV Reference Guide
Select camera to
view/configure
Each connected camera
must be enabled
Generation.
Document 900.0261
04/05