SMC Networks HRS100-A?-20-? Operation Manual page 143

30.
Perform setting for the contact input signal 1 with [▲] key or [▼] key, and press [SEL]
key to enter.
Set value
∗1: When the setting of the communication mode is "DIO mode", "External switch signal" cannot
be set.
∗2: When the setting of the communication mode is "SEIRAL mode" and the protocol setting is
"Simplified communication protocol 2", "External switch signal" cannot be set.
Setting/Checking: Contact input signal 1 type
31.
Press the [SEL] key once.
Setting screen of contact input signal 1 type is displayed on the digital display.
PV
SV
32.
Select the contact input signal 1 type with [▲] key or [▼] key, and press [SEL] key to
enter.
Set value
∗1: This can be set only when the contact input signal 1 is set to "Run/Stop signal input".
Setting/Checking: Contact input signal 1 delay timer for reading
33.
Press the [SEL] key once.
Setting screen of contact input signal 1 delay timer is displayed on the digital display.
PV
SV
HRS Series
Table 5.21-16 Setting for contact input signal 1
Explanation
No signal input
Run/Stop signal input
External switch signal input (N.O. type)
External switch signal input (N.C. type)
Table 5.21-17 Setting of contact input signal 1 type
Explanation
Setting/checking is not available when contact
input signal 1 setting is OFF.
Alternate signal
∗ 1
Momentary signal
Chapter 5 Display and setting of various functions
∗ 1, ∗ 2
∗ 1, ∗ 2
HRX-OM-S004
Initial value
(Default setting)
✓
Initial value
(Default setting)
✓
5.21Communication function
5-77