SMC Networks HRS100-A?-20-? Operation Manual page 117

Display Content
Operation setting when
"DC line fuse cut" alarm is
generated
Temperature alarm
monitoring mode setting
Monitoring start timer
Range over detection
timer
Compressor stop alarm
∗2: This alarm does not occur on the product of water cooled type.
HRS Series
Table 5.20-6 Default settings of the alarm customizing function (2/3)
Code
AL21
AL03
AL04
AL03
AL04
AL03
AL04
AL10
AL11
AL12
AL13
AL15
AL16
AL17
AL18
AL24
AL26
AL27
AL37
AL38
AL43
*2
AL45
Chapter 5 Display and setting of various functions
Object alarm
Alarm name
DC line fuse cut
Circulating fluid
discharge temp. rise
Circulating fluid
discharge temp. drop
Circulating fluid
discharge temp. rise
Circulating fluid
discharge temp. drop
Circulating fluid
discharge temp. rise
Circulating fluid
discharge temp. drop
High compressor intake
temp.
Low compressor intake
temp.
Low super heat temp.
High compressor
discharge pressure
Refrigerant circuit
pressure (high pressure
side) drop
Refrigerant circuit
pressure (low pressure
side) rise
Refrigerant circuit
pressure (low pressure
side) drop
Compressor running
failure
Compressor intake
temp. sensor failure
Compressor discharge
pressure sensor failure
Compressor intake
pressure sensor failure
Compressor discharge
temp. sensor failure
Compressor discharge
temp. rise
Fan failure
Compressor over
current
HRX-OM-S004
Change content
Product operation
while the alarm is
being generated
Monitoring method
Alarm will not be
generated during the
set period of time after
starting operation.
Alarm monitoring starts
when the set time has
passed.
An alarm will not be
generated for the set
period of time after the
circulating fluid
discharge temperature
becomes out of the set
range.
Alarm operation
5.20Alarm customizing function
Default
setting
A.STP
0
----
(0)
5
P.RUN
5-51