Table of Contents
Advertisement
REMOTE CLIENT SETUP
REMOTE CLIENT SETUP
REMOTE DVR SETUP (continued)
EVENT / SENSOR tab
• Alarm Input
Enable or disable alarm inputs, and select the type. (Enable / Disable, Normally Open / Normally Closed)
• Alarm Output
Select the conditions for activating an alarm relay output. (Alarm, Video loss, Motion)
Disk Event : Enable or disable alarm relay output activation based on detection of an HDD error.
Operation : Enable or disable alarm relay output.
Mode : Select the behavior of the relay when it is activated. (Latched or Transparent)
Type : Select the relay type. (Normally Open / Normally Closed)
Duration : Set the relay activation duration. (5 seconds to 5 minutes, or until a key is pushed on the DVR)
• Buzzer Output
Select the conditions that will activate the system buzzer. (Alarm, Video loss, Motion)
Buzzer : Enable or disable the system buzzer.
Duration : Set the buzzer time duration. (5 seconds to 5 minutes, or until a key is pushed on the DVR)
Disk Event : Enable or disable buzzer activation based on detection of an HDD error.
Keypad : Enable or disable buzzer chirp based on a Front Panel button press.
Remote Ctrl : Enable or disable buzzer chirp based on a Handheld IR Remote button press.
• HDD Event
Smart Alarm: ON/OFF.
Polling Time: The amount of time between tests.
• E-mail Notification
Check the E-mail Notification based on event type.
(Alarm, Video Loss, Motion)
Disk Event: Toggle ON/OFF sending an e-mail
notification when there is an HDD event detected.
Notification: Toggle ON/OFF sending an e-mail
notification when there is a system event detected.
83
Hide quick links:
Advertisement
Table of Contents
