Bench Press Cable - BodyCraft K2 Instruction Manual

STEP 12
Bolt end
1. Screw the threaded end of the Bench Press Cable II into the Single Pulley Block (43) (at
least one-third of the threads) as shown in inset S1, then route down and under the pulley
mounted on the Adj. Press Cam (27) as shown in inset S2. Mount the pulley using one
3/8" X 1-3/4" Hex Bolt (134) and one 3/8" Nut (159).
2. Continue routing the cable up to the receptor on the bracket welded on the Bench Press
Upright (20) as shown in inset S3.
Bench Press Cable ¢º
BENCH PRESS CABLE ¢º (62)
S1
20
S3
S2
27
18
S1
W3
101
S3
Metal ball end
S2
92
134
159