BodyCraft K2 Instruction Manual page 10

STEP 3
1. Attach the Cable Arm Connector (16) to the Front Upright (5) using two 3/8" X 3" Hex
Bolts (131), four 3/8" Washers (152) and two 3/8" Nuts (159). Attach the Cable Arm
Connector (16) to the pre-threaded holes in the Cable Arm Assembly (14), using two 3/8"
X 1" Hex Bolts (136) and two 3/8" Washers (152). Remember to keep all bolts loose to
ensure holes will align easily. Attach the Cable Arm Assembly (14) to the Base Frame (1)
using two 3/8" X 3" Hex Bolts (131), four 3/8" Washers (152) and two 3/8" Nuts (159).
2. Slide the axle of each Cable Arm (15) through the holes in the selector plates in the Cable
Arm Assembly (14) and fasten using the Axle Collars (89) and tightening by each 5/16" X
1/4" Set Screw (148). Check to ensure that each Cable Arm pivots freely and any cables
are not twisted.
Cable Arm Assembly
5
1
131
9
15
152
136
152
136 152
152
16
152 159
89
148
148
87
89
14
131
152
152
152
87 159
15