Top Cable - BodyCraft 50442 Assembly Instructions Manual

STEP 5
Assemble cables and pulleys simultaneously.
※Pulleys are mounted using 3/8" X 3" Hex Bolts (432), 3/8" Washers (438), and 3/8" Nylon Nuts
(441). Pay attention, as some places use washers, others don't.
1. Insert the threaded end of the Top Cable (416) between the pulleys in the front of the Right Cable
Height Adjuster (407R) as shown Fig. R1. Route the cable up and over two top Pulleys at the
Front and Rear of the Top Panel (405) as shown Fig. R2 & R3, then down to the Pulley Bracket
(409) as shown Fig. R4.
2. Continue routing over the two lower pulleys on the Top Panel (Fig R5 & R6) and then down to the
pulley in the welded bracket on the Right Base Frame (401R) as shown in Fig R7. Screw the
threaded end of the Top Cable (416) into the Bracket welded on the Right Cable Height Adjuster
(407R) AT LEAST one third of the way. This is a cable adjustment area. When all cables have
been tightened, make sure to secure the Jam Nut to prevent the Top Cable (416) from
unscrewing.
R2
R6
R8
R1
R7
Top Cable Assembly

TOP CABLE (416)

R3
R5
R4
R1
438
441
438
419
416
419
R2,R3
441
438
441
438
405R1
R2
R4
419
409
434
441
417
R7
419
441
434
401R
8
430
430
438
432
430
411
R3
419
438
432
419 405R2
438
432
R5,R6
438
R5
441
419
438
405R1
R6
405R2
R8
407R
438
432
438