Page 1
We stand behind our products. Every piece, every part of this BODYCRAFT strength training system is guaranteed for as long as you own it. We will repair or replace anything that goes wrong.
DESCRIPTION BASE CONNECTION FRONT BASE LEG PRESS SUPPORT REAR TUBE SLIDING SEAT SUPPORT FRAME SEAT SUPPORT SLIDING TUBE FOOT REST STEEL ROLLER HANDLE BAR SINGLE PULLEY BRACKET 50 ID. SQUA. END CAP 50 SQUA. END CAP RUBBER STOP RUBBER BUMPER NON-SKID PAD SPRING PIN 3/4"...
BASE FRONT CONNECTION(201) BASE(202) SINGLE PULLEY BRACKET(211) LEG PRESS SUPPORT(203) 3/4" STEEL RUBBER BUSHING(218) STOP(214) SPRING PIN(217) PULLEY(236) LEG-PRESS CABLE (234) (2030 mm) TOP CABLE(84A) (2890 mm) FASTENER 5/16" X 1/2" SETSCREW(228) 1/2" NYLON NUT(233) 3/8" X 2-1/2" HEX HEAD BOLT(224) 1/2"...
STEP1 1.Attach BASE CONNECTION(201) and LEFT WEIGHT BASE of Bodycraft Strata home gym using two 1/2" x 3-1/8" HEX HEAD BOLT(222), four 1/2" WASHER(229) and two 1/2" NYLON NUT(232). 2.Attach LEG PRESS SUPPORT(203) to FRONT BASE(202) using two 3/8" x 3"...
STEP2 To ensure best performance, lubricate all pivot points during assembly. Insert two 3/4" STEEL BUSHING(218) and four 1/2" STEEL BUSHING(219) to SLIDING SEAT SUPPORT FRAME(205). Attach SLIDING SEAT SUPPORT FRAME(205) to LEG PRESS SUPPORT(203) as shown using two STEEL ROLLER(209) as shown. Tighten 5/16"...
STEP3 Attach HANDLE BAR(210) and SEAT(237) to SEAT SUPPORT(206) as shown using two 3/8" X 1" HEX HEAD BOLT(226) and two 3/8" WASHER(231). Attach BACK PAD(238) on SEAT SUPPORT(206) as shown using two 3/8" x 2-1/2" HEX HEAD BOLT(224) and two WASHER(SMALL)(231). CHECK that all the parts are in assembled correctly as drawing then tighten all bolts.
LEG PRESS CABLE(234) If previously installed, completely remove TOP CABLE(84), along with pulleys T1, T2, T3, T4 and T5. Remove the two bolts and attach the TOP BEAM into the FRONT UPRIGHT. Assemble TOP CABLE(84A) (from leg press box) and pulleys simultaneously. Insert threaded end of TOP CABLE(84A) into slot in front of TOP BEAM, over pulleys T1, T2, around pulley T3, and over T4.
Page 9
Screw thread end of LEG PRESS CABLE(234) into SINGLE PULLEY BRACKET(211). Attach pulleys G2 and G3, making certain LEG PRESS CABLE(234) runs beneath pulleys and is scated in pulley grooves. Attach the eyelet cable end to ADJUSTMENT TUBE(207) as shown. G2,G3 201,202...