Weight Stack Assembly - BodyCraft K2 Instruction Manual

STEP 2
1. Attach the Gym Weight Base (18) and the Bench Press Weight Base (25) to the Base Frame (1)
using two 1/2" X 3-1/4" Hex Bolts (126), four 1/2" Washers (151) and two 1/2" Nuts (158). Insert
four plastic Guide Rod Holders (105) into the holes in each Weight Base (18 & 25). Also insert
four plastic Guide Rod Holders (105) into the holes in each Top Guide Rod Retainer (17 & 26) as
shown. Slide a Rubber Donut (111) onto one end of each Guide Rod (7). Insert the Guide Rods
(7) into the Plastic Guide Rod Holders (105) in each Weight Base (18 & 25) as shown.
2. Attach the Squat Foot Plate (21) and the Bench Press Upright (20) to the Bench Press Weight
Base (25) using two 1/2" X 3-1/4" Hex Bolts (126), four 1/2" Washers (151) and two 1/2" Nuts
(158). Cap the Squat Foot Plate (21) with one 50 X 75mm Plug (95) and the Bench Press Upright
(20) with one 50mm SQ Plug (98).
3. Slide each Weight Plate (48) over the Guide Rods (7). Make certain that each plate is oriented
with the selector hole on the bottom and facing forward. Attach the Top Plate (49) to the Selector
Rod (50) using the Top Plate Bolt (121). Tighten the Top Plate Bolt (121). Slide the Top Plate
(49) and Selector Rod (50) onto the Guide Rods (7).
4. Slide Gym Top Guide Rod
Retainer and Bench Top Guide
Rod Retainer (17 & 26) over top
of the Guide Rods (7) and
attach both Top Guide Rod
Retainers to the Top Frame (4),
using two 1/2" X 3-1/4" Hex
Bolts (126), four 1/2" Washers
(151) and two 1/2" Nuts (158).
5. Attach the Bench Press Upright
(20) to the Bench Top Guide
Rod Retainer (26), using one
1/2" X 3" Hex Bolt (127) (into
pre-threaded hole) and one 1/2"
X 3-1/4" Hex Bolt (126), three
1/2" Washers (151) and one
1/2" Nut (158) (through
bottom hole).
127
126
151
126
126
21
95

Weight Stack Assembly

151
126
151
158
98
151
151
111
20 151
105
126
158
151
25
151
26
151
126
105
50
49
121
7
48
64
105
158
151
151
126
8
158
17
151
105
7
4
111
105
158
151
18
151
1
158
151
105
50
121
49
64
48
158