Table of Contents
Advertisement
1. Screw the threaded end of the Connecting Cable (51A) into the Single Pulley Block (25) approximately half
way as shown inset C1.
2. Route the terminal end of the Connecting Cable (51A) over the top of the inside (right side) pulley mounted
on the Top Frame (3) as shown inset C2.
3. Continue the cable routing down and around pulley C3 mounted on top of the Base Frame (1) as shown
inset C3, using one 3/8" X 1-3/4" Hex Bolt (110) and one 3/8" Nut (130). The Connecting Cable (51A) enters
this pulley on the weight stack side and exits on the outside. Note: The pulley bracket welded to the base
frame directly behind the weight stack is not utilized unless you have purchased the optional Leg Press
Attachment. See the Leg Press assembly manual for routing of the leg press cable.
4. Mount a pulley in the second-from-bottom hole in the Floating Pulley Block (24) using one 3/8" X 1-3/4" Hex
Bolt (110) and one 3/8" Nut (130). Then continue the cable up and over this pulley as shown in inset C4.
5. Continue the cable routing down and under a pulley you will now mount in the slot in the Base Frame (1),
using one 3/8" X 2" Hex Bolt (111) and two 3/8" Washers (122). Enter the rear of the pulley and then slide
the cable through the Base Frame (1), exiting through the hole in the End Cap (64).
6. Run the cable through the slot in the front of the Seat Support (7) and attach the cable to Leg Extension
Cable Arm (18) as shown in inset C7, using one 3/8" X 3" Hex Bolt (107) and one 3/8" Nut (130).
7. Slide a pulley into the slot in the front of the Seat Support (7) and secure using one 3/8" X 2-3/4" Hex Bolt
(108), two 3/8" Plastic Pulley
Spacers (77), two 3/8" Washers
(122) and one 3/8" Nut (130) as
shown in inset C6.
C2
C4
C3
C5
STEP 5
CONNECTING CABLE (51A)
ball end
C1
C1
Connecting Cable
51A
3
108
25
51
C2
C3,C5
C5
111
10
bolt end
C4
130
61
51A
C6
C3
130
1
122
110
C7
C6
T5
51
24
130
110
61
51A
108
122
7
77
61
77
122
130
18
107
130
C7
Advertisement
Table of Contents
