BodyCraft K2 Instruction Manual page 11

STEP 4
We recommend two people for completion of this step.
1. Attach the Chromed Press Adjuster (27) to the Bench Press Arm (23) by inserting the Axle
of Bench Press Arm (46). Slide a Pillow Block Bearing (45) onto each end of the Axle of
Bench Press Arm (46).
2. Attach the two Pillow Block Bearings (45) to the Bench Press Upright (20) using two 1/2" X
3-1/2" Hex Bolts (125),four 1/2" Washers (151) and two 1/2" Nuts (158). Plug the back side
of the Press Arm (23) with two 25 X 50mm Plugs (97) and plug the front side of the Bench
Press Arm (23) with two 50mm Round Plugs (100).
3. Moisten the center of two Foam Pads (80) with water and then slide onto the Left and Right
Squat Handle Bars (28 & 29). Secure the pads with a (larger) 3/8" Washer (150) and a 3/8"
X 5/8" Inner Hex Screw (144).
100
28
Bench Press Arm Assembly
151
45
148
97
97
125
151
23
100
158
151 158
151
20
27
98
148
97
97
46
45
151
125
151
10