Main Frame Assembly - BodyCraft K2 Instruction Manual

STEP 1
To ease the assembly process, do NOT tighten bolts until instructed.
1. Attach the Rear Stabilizer (2), to the Base Frame (1) using two 3/8" X 3-1/8" Hex Bolts (130A), four
98
126
151
159
37
152
152
131
151
3
158
158
151
151
130A
152
2
152
94

Main Frame Assembly

151
158
4
158
131
151
151
128A
128A
5
152
94
152
152
152
131
159
159
1
158
151
94
3/8" Washers (152) and two 3/8" Nylon Nuts
(159). Attach Front Extended Frame (10) and
Front Stabilizer (6) to the Base Frame (1) using
two 1/2" X 3-1/4" Hex Bolts (126), four 1/2"
Washers (151) and two 1/2" Nylon Nuts (158).
Cap the Rear and Front Stabilizers (2&6) with
four 50mm SQ End Caps (94).
2. Attach the Rear Upright (3) to the
152
159
152
152
37
50mm SQ Plug (98).
3. Attach the Front Upright (5) to the Base Frame
(1), using two 3/8" X 3" Hex Bolts (131), four
3/8" Washers (152) and two 3/8" Nuts (159).
4. Attach the Top Frame (4) to the Rear Upright (3),
using two 1/2" X 3-1/4" Hex Bolts (126), four 1/2"
Washers (151) and two 1/2" Nuts (158). Attach
the Front Upright (5) to the threaded holes in
Top Frame (4) using two 1/2" X 1" Hex Bolts
(128A) and two 1/2" Washers (151).
5. Attach the Bar Hook (37) to the Top Frame (4),
using two 3/8" X 3" Hex Bolts (131), four 3/8"
Washers (152) and two 3/8" Nuts (159).
6. Attach the Foot Plate (11) to the Front Extended
Frame (10) by aligning the holes and inserting
the 1/2" Diameter Tube (72). Cap the 1/2"
Diameter Tube (72) with two 1/2" Round Plugs
(102). Secure the 1/2" Diameter Tube (72) by
159
tightening the pre-installed 5/16" X 1/4" Set
Screw (148).
152
158
151
94
6
151
126
102
7
bolts on the Rear Stabilizer (2),
using two 1/2" Washers (151), and
two 1/2" Nylon Nuts (158). Cap the
top of the Rear Upright (3) with a
151
126
102
148
10
11
72