Viewing Live Images With Spot Output; Changing Spot Output Manually; Changing Spot Output With Terminal Input On The Rear Panel - JVC VR-509E Instructions Manual

Viewing Live Camera Images

Viewing Live Images with SPOT Output

It is possible to view live images with the SPOT output function.
The following two methods for changing the display contents for
SPOT output are available:

• Changing SPOT output manually.

• Changing SPOT output with terminal input on the rear
panel.
Changing SPOT Output Manually
Press and hold the [SEQUENCE] button, and then press
the [SPLIT] button.
• The SPOT LED will be illuminated, and the SPOT OUT
SELECT mode will be activated.
• Switch between the contents that are to be displayed for
SPOT output using the same operations for monitor
output with the use of the [1] to [9], [SEQUENCE] and
[SPLIT] buttons.
Returning to the Monitor Output Selection Mode
Press and hold the [SEQUENCE] button, and then press
the [SPLIT] button.
• The SPOT LED will be extinguished, and the MONITOR
OUT SELECT mode will be activated.
26
Changing SPOT Output with Terminal
Input on the Rear Panel
Make up the [SPOT1] and [SPOT2] terminals on the rear
panel for 400 ms or more.
• The setup screen will change to SPOT output when the
SPOT1 and SPOT2 terminals are input.
SPOT1 SPOT2
MAKE OPEN
OPEN MAKE
OPEN OPEN
Displaying the next screen
When in the single screen mode: Switched alternately in the
sequence 1 → 2 → 3 → ... → 9 → 1 →
When in the 4 DIVISION mode: Switched alternately in the
sequence 4-A → 4-B → 4-C → 4-A ...
When in the 6 DIVISION and 9 DIVISION modes: Input is
disabled.
Displaying the previous screen
Switches the screens in the opposite sequence to that of
"Displaying the next screen."
Amending the layout
Switched alternately in the sequence SINGLE SCREEN
→ 4 DIVISION → 6 DIVISION → 9 DIVISION → SINGLE
SCREEN
Changing screen
Displaying the next screen
Displaying the previous
screen
No change