Playing Back Recorded Images; Playing Back Images; Playing Back During Recording (Simultaneous Playback Mode) - JVC VR-509E Instructions Manual

Playing Back Recorded Images

Playing Back Images

Plays back recorded images. This is activated by running a
search according to the date of the image to be played back
using "SEARCH DATE" (See page 43) or in accordance with
the time when alarm signals are received using the "ALARM
LIST SEARCH" feature. (See page 42)
1. Press the [PLAY/PAUSE] button.
• The "EVENT SEARCH" screen will be displayed.
EVENT SERCH
CONTINUOUS PLAYBACK
ALARM LIST SEARCH ..
SEARCH DATE
* * / * * / 2 0 * * * * : * *
SKIP SET ..
Play with PLAY / PAUSE button.
SKIP
LATEST EVENT
OLDEST EVENT
2. Select [CONTINUOUS PLAYBACK] with [ / ], and
then press the [SET] button.
• Playback will be started.
Pausing during Playback
3. Press the [PLAY/PAUSE] button.
• Playback will be paused.
• Press the [PLAY/PAUSE] button again to resume
playback.
Ending Playback
4. Press the [PLAY STOP] button.
• The screen will return to the "EVENT SEARCH" screen.
5. Press the [PLAY STOP] button once again.
• The "EVENT SEARCH" screen will close.
40
Playing Back Recorded Images
It is possible to view recorded images when in the Recording
mode.
This will not affect the images being recorded.
1. Press the [PLAY/PAUSE] button during recording.
2.
Playing Back during Recording
(Simultaneous Playback Mode)
• Images can be played back with the normal operations
even when recording is in progress.
The following modes of playback are possible when in the
Simultaneous Playback mode:
• Normal playback
• Search Date (Page 43 "Searching for Images According
to Date/Time")
• Jog/Shuttle Playback (Page 43 "Adjusting Playback
Speed")
• Skip Playback (Page 44 "Skipping Recorded Images")
CAUTION
• There are cases where playback images are displayed
after a delay when playback is activated at the same
time as recording, but this has no adverse effects on
the recording.
• In order to ensure that the hard disk is kept in its
optimal status, the VR-509E will periodically enter the
maintenance mode automatically. When maintenance
is in progress there are cases where the audio sound
may break up or the images be displayed after a delay
during playback. In this event, wait until the
[MAINTENANCE PROCEEDING] message has
disappeared before restarting playback.
• There are cases where images recorded close to the
times of power failures will not playback normally.
• The VR-509E uses a special recording method that
may result in a loss of synchronization between the
images and the audio sound, depending on the setup
conditions.