Setting Up A Network For Vr-509 - JVC VR-509E Instructions Manual

Connecting to a PC

Setting up a Network for VR-509

Perform the initial setup procedure for the VR-509 while
referring to the connected monitor screen.
1. Press the [MENU] button.
• Opens the menus in accordance with the instructions
provided in Changing MENU Settings (page 17) in the
sequence of "MENU" → "DETAIL OPERATION" →
"NETWORK".
NETWORK
HOST NAME
METHOD
IP ADRESS
NET MASK
DEFAULT GATEWAY
DNS SERVER
MAC ADDRESS
2. Select [HOST NAME] with the [ / ] keys, and then
press [SET].
• The host name entry screen will be displayed.
HOST NAME
***** ***** ***** ***** ***** *****
***** ***** ***** ***** ***** *****
***** ***** ***** *****
DECISION
3. Select your desired character with the [ / / / ]
keys, and then press [SET].
• A single character will be entered in the host name.
* Press the [–] or [+] keys to move the cursor backward and
forward along the name.
• Press the [CANCEL] button to delete the character in the
name over which the cursor is located.
4. Select [DECISION] with the [ / ] keys, and then press
[SET].
• The screen will return to the [NETWORK] screen.
5. Select your desired item with the [ / / / ] keys, and
then change the value of the setting with [–/+].
* The factory default settings are listed below.
• METHOD: STATIC (DHCP servers cannot be used.)
• IP ADDRESS: 192.168.0.10
• NET MASK: 225.225.225.0
• DEFAULT GATEWAY: 192.168.0.254
Consult with the network administrator for details on the
settings required to connect the recorder to a LAN network.
66
vr509
STATIC
192.168. 0. 10
255.255.255. 0
2.
192.168. 0.254
0. 0. 0. 0
00:80:88:40:b0:00
3.
4.
6. Press the [SET] button.
• The settings will be saved.
• When a DHCP server has been set for METHOD, the IP
address allocated by the DHCP server will be displayed
the next time this menu is opened (cannot be amended.)
• When [DHCP] has been set for METHOD, the IP
address acquisition process will only be performed when
the recorder is rebooted or when the setting is amended
to an IP address. If the network is enabled after a certain
period of time has passed since rebooting, amend the
METHOD setting to something different, and then
change it back to [DHCP] in order to acquire the IP
address.
• If setting acquisition from the DHCP server failed with
[DHCP] set as the setup method, the previous STATIC
IP values will be set.
* Press the [RETURN] button to return to the previous screen.