Making Normal Recordings; Making Normal Recording With The Ext Rec I/O Terminals; Recording Status Notification - JVC VR-509E Instructions Manual

Making Normal Recordings

STANDARD MODE
1. Set up the DETAIL REC parameters. (See page 30)
2. Set the normal recording parameters with [STANDARD
MODE]. (See page 31)
3. Check to confirm that the LED for TIMER/MODE is
extinguished.
Press the [REC/STOP] button.
• Recording will be started.
Press the [REC] button for approximately two
consecutive seconds.
• Recording will be stopped.
REC PATTERN 1 to 9
1. Set up the DETAIL REC parameters. (See page 30)
The desired REC PATTERN mode can be set with the
[TIMER/MODE (REC PATTERN)] setting on the [DETAIL
REC] screen (select from REC PATTERN 1 to 9.)
2. Set the normal recording parameters with [REC
PATTERN 1 to 9]. (See page 31)
3. Press [TIMER/MODE].
• The TIMER/MODE LED will be illuminated.
Press the [REC/STOP] button.
• Recording will be started in accordance with each normal
mode setting.
Press the [REC] button for approximately two
consecutive seconds.
• Recording will be stopped.
MEMO
• The contents from the start to the end of recording are
saved on the hard disk as a single event.
• The [REC] indicator on the front panel will be
illuminated during recording if the [REC INDICATOR]
setting on the [OPERATION] screen is set at [ON].
• It is possible to set the operations that are to be
performed when the hard disk runs out of space with
the [REPEAT REC] setting on the [OPERATION]
screen. When the [REPEAT REC] setting is set at
[ALARM LOCK] or [ALL], recordings will be written over
the oldest recordings to enable operations to continue.
(See "Operation Setup" on page 32)
Making Normal Recording with the EXT
REC I/O Terminals
Enables the start and stop operations when recording to be
controlled by signals input to the [EXT REC IN] terminal on the
rear panel, instead of the [REC/STOP] button.
1. Set the [EXT REC IN] setting to [TRIGGER] or
[MANUAL]. (See page 49)
When the [EXT REC IN] is set at [TRIGGER]
• Normal recording is started when the [EXT REC IN]
terminal is set to [MAKE].
• Press the [REC/STOP] button for approximately two
consecutive seconds to stop recording.
When the [EXT REC IN] is set at [MANUAL]
• Normal recording is started when the [EXT REC IN]
terminal is set to [MAKE].
• Recording is stopped when the [EXT REC IN] terminal is
set to [OPEN].

Recording Status Notification

The status of the recording can be examined during recording
with the use of the LED lamps and the signals output from the
[REC OUT] terminal.
• Setting the operations for the recordings LEDs. (See
page 32)
• Setting the [REC OUT] terminal. (See page 49)
Recording Camera Images
29