Table of Contents
Advertisement
Explanations
Troubleshooting
Problems Related to Error Code and Onscreen Display
Onscreen Display
"E-01 DETECTED." *1, *2
"E-02 NO IDE 1 HDD"
"E-02 NO HDD"
"E-02 IDE 1 FORMAT NG"
"E-02 MIRRORING NG"
"NO VIDEO IN** INPUT (E-03)" *2
"E-05 DETECTED." *1, *2
"E-06 DETECTED." *1, *2
"E-07 DETECTED." *1, *2
"E-08 DETECTED." *1, *2
"E-09 DETECTED." *1, *2
"E-10 DETECTED."
"POWER OUTAGE LOG IS
UPDATED." *2
*1 to *3: See the next page
96
•
System restarted due to error in the functioning of the hard disk.
•
Continues operation with the intact hard disk.
•
The data in the disconnected hard disk will not be recovered if the
manual scan disk is executed.
→ Switch the power supply off and then on again, and try the formatting or
defrag functions once again.
→ Consult your nearest JVC dealer.
•
Abnormality with hard disk operations (cannot be started up.)
→ Switch the power supply off and then on again, and try the formatting or
defrag functions once again.
→ Consult your nearest JVC dealer.
•
No video input signals.
→ Stop operations and check the connection.
→ Double-check settings in the "Instruction Set-1" Menu.
* Recording may fail if it is continued after the error message is displayed.
Set the "CAMERA" setting to "DISCONNECT" in the "Instruction Set-1"
Menu or eliminate the cause of the error immediately.
•
Error in the fan motor.
→ Consult your nearest JVC dealer.
•
EEPROM error.
→ If this error occurs due to alteration of a menu setting, turn the equipment
off/ on and check the setting.
→ If this error keeps occurring due to alteration of a menu setting or during
operation, consult your nearest JVC dealer.
•
Codec 1 error. (Mostly used for recording and VR-509E playback)
*
HDD/DVD playback, and recording onto the HDD will not be carried out
normally if this is displayed.
→ Consult your nearest JVC dealer.
•
Codec 2 error. (Mostly used for transmission and DVD trans-coding)
*
USB still image capturing, DVD export processing and live/playback
transmission to the network will not be carried out normally if this is
displayed.
→ Consult your nearest JVC dealer.
•
Error on one of the built-in hard disk drives. (This error is detected only
when in the Mirroring Setting mode.)
→ Consult your nearest JVC dealer.
•
Abnormality with the DVD drive.
→ Consult your nearest JVC dealer.
•
Displayed when a power outage occurs.
→ This is not an error. Press the [CANCEL] button to clear the message.
Cause and Recovery
Refer
to
Page
–
–
P15
P20
–
–
–
–
–
–
P54
Advertisement
Table of Contents
Troubleshooting
