Table of Contents
Advertisement
Using the Motion Detection Function
There are two methods of performing motion detection: 1) with
a pre-determined set of parameters, and 2) by freely setting
detection sensitivity. It is also possible to set the area for which
detection is to be carried out on the screen.
* Motion detection is not possible when operations are being
carried out on the menu.
Motion Detection with Pre-Determined
Sensitivity
Select either [STANDARD] or the scene name as the [MOTION
DETECTION] setting on the [OPERATION SET] screen to
perform motion detection with a pre-determined set of
parameters. The parameters for the scene name are shown in
the table below.
Table #1: Parameters for Each Scene
Scene
Dynamic
Sensitivity
Level
Normal
8
User
[1 to 10]
8: default*
Entrance High
9
Entrance Low
8
Passage High
9
Passage Low
8
Register High
9
Register Low
8
ATM High
8
ATM Low
7
Lobby High
10
Lobby Low
9
Aisles High
10
Aisles Low
9
Car Park High
10
Car Park Low
9
Low Lighting
10
High
Low Lighting
10
Low
Elevator
9
Counter
7
* Default: The value set when the unit is shipped from the
factory.
This can be selected from [DYNAMIC SENSITIVITY
LEVEL], [STOP LEVEL] and [TARGET AREA
LEVEL] on the [ALARM REC] setup screen
(Page 34).
Detailed Settings
Target
Stop Level
Area Level
2
2
[1 to 3]
[1 to 10]
2: default*
2: default*
1
1
3
2
1
1
3
2
1
1
3
2
1
1
3
3
1
1
3
2
1
1
3
3
1
1
3
3
1
1
3
2
2
1
2
2
Dynamic Sensitivity Level:
The level value for detection. The higher the value,
the higher the sensitivity (1 to 10).
Stop Level:
The offset value for the level of operation sensitivity.
The larger the value, the more difficult to
discontinue alarm detection (1 to 3).
Target Area Level:
The value for the size of the subject to be detected.
The higher the value, the more difficult it is to detect
small motions (1 to 10).
The relationship between the target area level and the
detection area count is shown in the table below.
Table #2: Target Area Level and Detection Area Count
Target Area Level
Detection Area Count
Target Area Level
Detection Area Count
MEMO
•
The Target Area Level is the setting for determining
movement in areas more than the number of detection
areas count in Table #2.
•
The setting for the Target Area Level cannot exceed
the parameter setting for [MOTION DETECT AREA
SET] on page 37. Select the relevant Target Area
Level for the number of detection areas in Table #2.
•
The number of alarms will increase when motion
detection has been set to be carried out frequently.
Note that this may result in alarm searches requiring
additional time during playback.
•
There are cases where motion detection will be
mistakenly triggered owing to flickering fluorescent
lights when the camera is connected. In this event, set
the camera settings to flickerless.
Recording Camera Images
1
2
3
4
1
2
4
6
6
7
8
9
10
15
20
25
5
8
10
30
35
Advertisement
Table of Contents
Troubleshooting
