Part Names And Functions (Signal I/O Terminals) - JVC VR-509E Instructions Manual

Part Names and Functions (Signal I/O Terminals)

WARNING:
SHOCK HAZARD
-DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE-NE
PAS OUVRIR
AC IN 220V - 240V
50Hz/60Hz
[ALARM IN 1 to 9] Terminals 1 - 9
1
ALARM REC is activated when signals are input to these
terminals. (Page 33)
[EMERGENCY] Terminals
2
EMERGENCY REC is activated when signals are input to
these terminals. (Page 33)
[CLOCK RST IN] Terminal
3
The terminal for resetting the time. The VR-509 clock is
reset when signals are input. (Page 19)
[CLOCK RST OUT] Terminal
4
The clock reset signal is output in accordance with the
following timing:
• When the VR-509 internal clock is 00:00 or 12:00.
[ALARM RESET] Terminal
5
Recording is stopped when this signal is input in the
ALARM REC mode.
[REC OUT] Terminal
6
Outputs the recording status of the VR-509. (Page 29)
1 2 3 5
4
[WARNING OUT] Terminal
7
Outputs a signal when an operation abnormality or other
error occurs on the hard disk. (Page 96)
[EXT REC IN] Terminal
8
Activates recording with an external signal. (Page 29)
[OPE ON/OFF] Terminal
9
Switches between OPE ON or OFF when the signal is
input. (Page 16)
[SPOT 1· 2] Terminal
10
The input signal selects the image to be output with SPOT
OUTPUT. (Page 26)
[COMMON] Terminal
11
The common grounding terminal. Connected to the signal
grounding terminal on the device connected.
[SIGNAL GND] Terminal
12
The common grounding terminal. Connected to the signal
grounding terminal on the device connected.
(This can be used when there are insufficient common
grounding terminals.)
* Do not use this terminal for protective earthing.
7 9
6 8 10
11
Getting Started
12
13