Replacing The Transfer Belt Unit - Konica Minolta Magicolor 8650 Service Manual

Field Service Ver. 2.0 Nov. 2007
3.4.16

Replacing the transfer belt unit

A. Periodically replacing parts/cycle
• Transfer belt unit: Every 150,000 prints
B. Removal procedure
1. Remove all toner cartridges.
See toner cartridge replacement/removal procedure steps 1 through 3.
See P.35
2. Remove all imaging units.
See imaging unit replacement/removal procedure steps 1 through 3.
See P.31
3. Open the right door.
[1]
[2]
Confidential – for internal use only, do not distribute
[2]
[1]
A02EF2C299DA
A02EF2C301DA
[1]
A02EF2C303DA
3. Periodical check
4. Remove two screws [1] and release
the lock of the transfer belt unit [2].
5. Hold the both sides and lift it to take
out the transfer belt unit [1] a little.
6. Hold the position [1] as shown in the
left and remove the transfer belt unit
[2].
NOTE
• Do not touch the surface of the
Image transfer belt unit.
• Cover the image transfer belt unit
with something such shade cloth to
protect its surface from dust or for-
eign matter.
37