Konica Minolta Magicolor 8650 Service Manual page 200

Field Service Ver. 2.0 Nov. 2007
(2) IP Setting
Functions • To set whether to enter the IP address directly or to obtain it automatically.
Use • To change the method for setting the IP address.
Setting/ • The default setting is Auto Setting.
Procedure
• When it is set to [Auto Setting], select the method to obtain it automatically.
DHCP Setting
BOOTP Setting
ARP/PING Setting :
AUTO IP Setting
NOTE
• [ARP/PING Setting] and [Auto IP Setting] cannot be set to "OFF" simulta-
neously.
• They will all be set to "ON" when [Manual Input] is changed to [Auto Setting].
•
When it is set to [Manual Input], set the IP address, subnet mask and default gate
way.
(3) IPv6
Functions • To set whether to use IPv6 in IP network communication.
• To set whether to use the IPv6 address automatic acquisition setting.
• To set IPv6 addresses.
Use • To use IPv6 in IP network communication.
Setting/ <IPv6 Setting>
Procedure • The default setting is ON.
<Auto IPv6 Setting>
• The default setting is ON.
NOTE
• When the setting is changed, turn off the power switch and turn it on again
more than 10 seconds after.
<IPv6 address>
• When [Auto IPv6 Setting] is set to OFF, make the settings of global address and gate-
way address.
1. Select [Global Address] or [Gateway Address].
2. Enter the address using
3. To change the prefix length of global address, select [Prefix Length] and specify the
number of bits within the range of 1 to 128.
NOTE
• [LinkLocal Address] key appears, but its settings are not allowed to be
changed.
Confidential – for internal use only, do not distribute
Manual Input
: ON
: ON
ON
: ON
"ON"
"ON"
and keys.
8. Utility Mode
"Auto Setting"
OFF
OFF
OFF
OFF
OFF
OFF
159