Image Controller; Unit Replacement - Konica Minolta Magicolor 8650 Service Manual

Field Service Ver. 2.0 Nov. 2007
10.3.6

Image Controller

A. Select Controller
Functions • To set the type of the controller.
Use • Use when changing the type of the controller.
Setting/ • Select the controller to be used.
Procedure "Controller 0"
Controller 1
Controller 2
Controller 3
Others
NOTE
• When the following setting is "ON", this setting should be set to "Controller
0".
[Admin. Settings] → [Security Settings] → [EnhancedSecurity] When
[EnhancedSecurity] is set to "ON", this setting cannot be changed.
• After changing setting, make sure to turn off the power switch and turn it on
again more than 10 seconds after.
B. Controller Mode
Functions • [Controller Mode] appears when [Others] is selected.
Use • Use when changing the type of the controller.
Setting/ * This setting is available when the Select controller setting is set to "Others."
Procedure Mode 1: undefined.
Mode 2: undefined.
Mode 3: undefined.
10.3.7

Unit Replacement

Functions • To select who is to replace a unit.
• When the unit life arrives, the warning display is intended for the specific person who
is going to replace the unit.
When "User" is selected
When "Service" is selected: Life warning.
Use • Use when changing the specific person who is going to replace the unit.
Setting/ • The following are the default settings:
Procedure
Toner Cartridge
Waste Toner Box
Imaging Unit
Punch Scrap Box
NOTE
• If the destination is changed in [Destination], set all of this function to "User."
Confidential – for internal use only, do not distribute
: The standard controller is used.
: undefined.
: undefined.
: undefined.
: undefined.
: Printing is inhibited.
US, Japan, Others 4
: "User" Service
: "User" Service
: "User" Service
: "User" Service
10. Service Mode
Europe, Others1/2/3
"User" Service
"User" Service
"User" Service
"User" Service
211