3. Other
3.2
Precautions to be observed when option configuration is
changed
• The output tray detection position must be changed depending on configuration of the
options mounted on the printer.
3.2.1
Setting the exit tray detection position
A. When only OT-602, MT-502, or SD-505 is mounted
B. When OT-602 + MT-502 or OT-602 + SD-505 are mounted
C. When only FS-519 is mounted
18
Confidential – for internal use only, do not distribute
[1]
[2]
9J08F2C511DA
[1]
[2]
9J08F2C512DA
[1]
[2]
9J08F2C513DA
Field Service Ver. 1.0 Oct. 2007
1. Loosen the screw [1] and move it in
the direction of the arrow. Then,
tighten it at the new position.
NOTE
• This step should be done securely.
If not, any trouble may happen.
• Be sure to move the screw itself.
• Do not move the screw by using the
adjust plate [2].
1. Loosen two screws [1] and move
them in the direction of the arrow.
Then, tighten them at the corre-
sponding new positions.
NOTE
• This step should be done securely.
If not, any trouble may happen.
• Be sure to move the screw itself.
• Do not move the screw by using the
adjust plate [2].
1. Loosen two screws [1] and move
them in the direction of the arrow.
Then, tighten them at the corre-
sponding new positions.
NOTE
• This step should be done securely.
If not, any trouble may happen.
• Be sure to move the screw itself.
• Do not move the screw by using the
adjust plate [2].