Field Service Ver. 2.0 Nov. 2007
F. SNMP
(1) SNMP Setting
Functions
• To set whether to use SNMP (Simple Network Management Protocol) or not.
• To set the SNMP version to be used.
Use
• Not to use SNMP.
• To readout management information base and to enter community name for writing.
Setting/
• The default setting is ON.
Procedure
• To individually set whether or not to use SNMP v1/v2c (IP), SNMP v3 (IP), and
SNMP v1 (IPX).
• The default setting is ON.
(2) UDP Port Number
Functions
• To set the UDP standby port number which is used for SNMP (IP).
Use
Setting/
• Enter the port number between 1 and 65535 using
Procedure
(3) SNMP v1/v2c Setting
Functions
• To conduct setting when using SNMP v1/v2c.
Use
• To use when changing write setting.
• To use when entering the community name for reading the Management Information
Base (MIB) and writing to it.
Setting/
<Read Community>
Procedure
• Enter a Read community name.
<Write Setting>
• The default setting is ON.
NOTE
• [ON] cannot be selected when the following setting is set to "ON."
[Admin. Settings] → [Security Settings] → [EnhancedSecurity]
<Write Community>
• Enter a Write community name.
(4) SNMP v3 Settings
<Context Name>
Functions
• Set the context name which is used for SNMP v3.
Use
Setting/
• Enter the context name (up to 64 characters) using
Procedure
Menu/Select key.
Confidential – for internal use only, do not distribute
"ON"
"ON"
"ON"
8. Utility Mode
OFF
OFF
and
keys.
OFF
and
keys, and press the
171