Konica Minolta Magicolor 8650 Service Manual page 193

8. Utility Mode
(4) Spool Setting
Functions
• To set whether to store the print data to HDD when receiving the next job during RIP
process of the current job.
Use
Setting/ • The default setting is ON.
Procedure
(5) Paper Size Switch
Functions • To set whether to switch between A4 and Letter (8
Ledger (11 x 17) size paper in reading.
Use • To output Letter (8
ument to A3 size.
• To output A4 size document to Letter (8
ger (11 x 17) size.
NOTE
• When switching the size, the image will be printed in the same magnification.
• The image will not be reduced when there is image deficiency.
Setting/ • The default setting is OFF.
Procedure
(6) Banner Sheet
Functions • To set whether or not to print on the banner (front cover) page.
Use • To use when the banner (front cover) page is to be printed.
Setting/ • The default setting is OFF.
Procedure
(7) Binding Pos. Adjust
Functions • Specifies the alignment between the sides of paper (binding position adjustment) in
duplex printing.
Use • To achieve faster printing performance, select Productivity. To address misalignment
problems between sides of prints in the horizontal and vertical directions, select Fin-
ishing.
Finishing
Productivity
ControlAdjustment
Setting/ • The default setting is Finishing.
Procedure
152
Confidential – for internal use only, do not distribute
"ON"
1 / x 11) size document to A4 size, and Ledger (11 x 17) size doc-
2
ON
ON
: Able to optimize sides aligning operation as the process is
performed after the machine receives all of the print data.
: Able to accelerate print speed as sides alignment proceeds
together with data reception and print operation.
: Comply with the command from the printer driver and does
not take the side alignment step.
"Finishing" Productivity
Field Service Ver. 2.0 Nov. 2007
OFF
1 / x 11) size paper, and A3 and
2
1 / x 11) size, and A3 size document to Led-
2
"OFF"
"OFF"
ControlAdjustment