Registering Devices; Selecting Automatically Detected Cameras And Registering Them Simultaneously - Sony NSR Series User'smanual

Example: When [Device] is clicked:
The Device Configuration screen appears.

Registering Devices

You can register the devices to manage with NSR, and
configure detailed settings for the operation of the devices.
There are the following way of registering devices.
• Register a camera on the network automatically
For details on automatic camera registration, refer to the
Installation Manual.
• Selecting Automatically Detected Cameras and
Registering Them Simultaneously (page 33)
Detect the devices that exist on the same network as
NSR automatically, select the cameras to register, and
then register them simultaneously.
• Registering Devices Manually (page 35)
Specify the IP address of a device, and register the
device individually.
Notes
• When using non-Sony IP cameras (network cameras),
simultaneous registration through basic configuration
and automatic detection is not possible. Register the
cameras manually.
• A separate registration procedure is necessary to control
pan, tilt, and zoom on an analog camera. For details, see
"Configuring Control Protocol of Analog Camera"
(page 48).
Selecting Automatically Detected
Cameras and Registering Them
Simultaneously
You can detect the devices that exist on the same network
as NSR automatically, select the cameras to register, and
then register them simultaneously. You can also configure
the IP addresses and port numbers of the cameras during
registration. Entering the administrator ID and password
of cameras enables you to register the devices.
1
Click [Device] at the top of the Configuration window.
The Device Configuration screen appears.
33
Registering Devices