Table of Contents
Advertisement
Setting Items of [VMD] Tab (VMD (Camera))
This tab is displayed by clicking [Device] in the
[Configuration] window, and selecting [VMD (Camera)]
on the VMD tab.
After changing the settings, click [Apply] to save your
settings.
Note
The setting items F differ depending on the camera you
are using.
A
B
A Enable
Select the check box to enable the motion detection
function.
B Type of Motion Detection Function
Select [VMD (Camera)] here.
The following setting items differ depending on the motion
detection function that is selected here.
C Pulse
Select the check box when you wish to specify a pulse
duration and input a pulse.
If you select this, enter a value for [Pulse Duration].
Pulse Duration
Enter the duration in milliseconds to sustain pulse
input from the VMD (camera) pin once it is turned on.
D Preview
This displays the images from the camera.
Use the following procedure to create an area for detecting
motion.
• Click and drag the mouse over the image to create a
motion detection area (red frame).
By dragging each edge of the area, you can change the
size of the area.
• Enter pixel values in the [Active Area] boxes to set the
motion detection area.
E
For a camera equipped with pan, tilt, and zoom functions,
use this to change the direction and zoom of the camera
when configuring an area.
F Camera Position
Select the camera position to configure.
Current Position
Select this option when configuring the settings for the
current camera position.
Preset Position
Select this option when configuring settings for each
C
preset.
E
If you select this, select a preset from the drop-down
menu, and move the camera to that preset position.
D
When the camera is moved to the preset position you
specified, the settings for that position are enabled.
F
The settings for one preset position cannot be used for
another preset position.
Object Type
Select [Moving] or [Unattended].
The following items differ for [Moving] and [Unattended].
You can only configure one of [Moving] and [Unattended]
GH
within each screen.
• When Moving:
Threshold
Enter a value for the threshold for motion detection.
• When Unattended:
Detection Time
Enter from 40 to 43200 (seconds) for the time from when
an object stops moving until the object is detected as
unattended and an alarm is triggered.
The countdown is reset if the object starts moving again
during the specified duration.
Caution
After an unattended object is detected (after the alarm
occurs), another unattended object may not be detected for
up to one minute.
Area 1 to Area 4
Select Active or Inactive for each detection area.
Minimum Detectable Object Size
Enter a minimum size for the object to be detected.
Alternatively, configure the size by using the mouse to
drag the minimum detectable object size setting frame
(light blue). You can change the size by dragging each of
the edges. The setting frame cannot be deleted.
Configuring Motion Detection Settings
63
Advertisement
Table of Contents
