Table of Contents
Advertisement
xSetting Items of Network Device 1 to 3
Configure each item, and click [OK].
Configure the settings as follows in accordance with your
environment.
To use a DHCP to obtain the address setting automatically:
Select [DHCP].
To configure the address setting manually:
1 Click [Static].
2 Enter the following address.
IP Address
Enter the IP address.
Caution
• Before you enter the IP address, make sure there is
no machine that uses the same value on the same
network. Even if a machine that uses the same value
does exist, an error message will not be displayed.
However, be careful because more than one machine
using the same value will result in incorrect
operation.
• Even if you set an IP address that is prohibited under
the IP address assignment rules, it will not be
reflected in the system.
Example: 224.0.0.0 to 255.255.255.255
0.0.0.0
127.0.0.1, etc.
Netmask
Enter the subnet mask.
Note
The default values for a network device are shown
below.
IP Address: 192.168.[0/1/2]
Netmask: 255.255.255.0
1)
The setting values for each of the network devices [#1/#2/
#3].
1)
.1
Route Setting
Click this when you need to configure the route to
another network.
Configure the settings as follows on the Route For
Network Device 1 screen that appears.
1 Enter the address, gateway, and netmask of the
other network to which to connect, and click [Add]
to add the network to the list.
For details, contact the administrator of the network
to which you will connect.
2 Click [OK].
Setting Items of Monitor Menu Screen
Select the monitor you want to configure, and click
[Select].
When you want to use two monitors connected to NSR,
selecting the [Dual Head] check box allows you to
configure the second monitor.
Caution
After you configure the second monitor, the system needs
to be restarted while the second monitor is connected.
Changing Initial Settings with the Setup Menu
15
Advertisement
Table of Contents
