Logging On; Registering Cameras - Sony NSR-1000 Series Installation Manual

The unit restarts.
↓
The logon screen appears.
Continue to the following section, "Logging On."
To access the Setup Menu from the logon
screen
Click [Administration Menu].
1
↓
Click [Setup Menu].
2
When patch files are available
You can install patch files distributed by Sony onto the
NSR.
Patch files are distributed by Sony as more NSR-
compatible cameras and functions are added. We
recommend installing these patch files to operate the
NSR using the most up to date software.
For details on installing the patch files, see "Installing
Patch Files" (page 34).
24
Step 3: Settings

Logging On

Enter the user name and password, and click [Logon].
Default user name: admin
Default password: admin
When logon is successful, the Automatic Camera
Registration dialog appears.
Notes
• Only Sony cameras will be located and registered.
• Only cameras with IP address settings that have not
been changed from factory default conditions will be
located and registered. To register cameras with IP
addresses that have been changed, use [Easy Setup]
(page 25), or return the camera IP address settings to
default conditions and restart the unit.
• If you want to manually specify cameras for
registration, click [No] and proceed to the next
section, "Registering Cameras."
• If you select the [Do not show this dialog box again]
check box, this dialog box will not appear on
subsequent startup of the software, and cameras will
not be located. If you selected this check box
previously and want to perform automatic camera
registration again later, configure settings in the
[Administration Menu] to reenable display of this
dialog box. For details on the [Administration Menu],
refer to the User's Guide (PDF).

Registering Cameras

You can register cameras using one of the following
methods: register cameras using Easy Setup; select
cameras that were automatically detected and then
register them simultaneously; or register devices
manually.