Registering Devices; Changing Registration Details - Sony IPELA NSR-500 Series User Manual

The Configuration window appears.
3
Click the button of the item you want to set at the top
of the window.
The configuration screen that corresponds to the
button appears.
Example: When [Device] is clicked:
The Device Configuration screen appears.
34

Registering Devices

Registering Devices
You can register the devices to manage with NSR, and
configure detailed settings for the operation of the devices.
There are the following way of registering devices.
• Registration Using Easy Setup
Register cameras on the network automatically. For
details on the operation, refer to the Installation Manual
(separate document).
• Selecting Automatically Detected Cameras and
Registering Them Simultaneously
Detect the devices that exist on the same network as
NSR automatically, select the cameras to register, and
then register them simultaneously. For details on the
operation, refer to the Installation Manual (separate
document).
• Registering Devices Manually
Specify the IP address of a device, and register the
device individually. For details on the operation, refer to
the Installation Manual (separate document).
Notes
• When using non-Sony IP cameras (network cameras) or
ONVIF (Open Network Video Interface Forum)
cameras, simultaneous registration through basic
configuration and automatic detection is not possible.
Register the cameras manually.
• Control protocol configuration is necessary to control
pan, tilt, and zoom on an analog camera. For details, see
"Configuring Control Protocols for Analog Cameras"
(page 50).

Changing Registration Details

This section describes the procedure for changing the
settings on the [General] tab of the Device Configuration
screen.
The items on the [General] tab allow you set multiple
cameras simultaneously.
Note
Some of the setting items differ depending on whether you
are configuring the settings of one camera or the settings
of multiple cameras simultaneously.
• A blank is displayed for setting items with which the
setting state differs for each camera. If these setting
items are saved as is, the corresponding setting items of
each camera are not modified. Reselecting an item from
a list or entering a numeral sets the new value for all of
the cameras.