Table of Contents
Advertisement
Setting Items of New Record Dialog Box
This dialog box is displayed by clicking [New Record] on
the Schedule screen (page 84).
The items that are displayed differ depending on the type
of recording.
After configuring each item, click [OK].
Screen Example: When alarm recording (recurrent schedule)
A
B
C
A Schedule Record/Alarm Record/Event Record
Select the type of schedule to configure.
B Name
Enter the name of the schedule. It can be up to 32
characters long.
C Enable
Select the check box to enable this schedule.
D Schedule
The settings differ depending on whether you are
configuring a recurrent schedule or a schedule for a
specific date and time.
When recurrent schedule:
Select the check boxes for the days you want to run the
schedule, and configure a start time and end time for
the schedule.
The range that can be specified is 00:00:00 to 24:00:00
(hours/minutes/seconds).
When schedule for a specific date and time:
Configure the start date and time and end date and time
to apply the schedule.
84
Configuring Recording Schedules
E Record Duration
This item is displayed in the case of alarm recording or
event recording.
Set the record duration for when an event occurs.
Record Start
Select the timing for starting recording.
D
EF
G
H
I J
Record End
Select the timing for ending recording.
Event Start
This starts recording when an alarm or event started
(point in time the alarm signal became active).
Pre Event Start
This goes back to record the images before an alarm
or event started.
When this is selected, enter the period to go back to
record within the range of 1 to 60 seconds.
Note
Pre alarm/event start recording cannot be
performed for audio.
From Event Start
This ends recording at the point in time a specified
period of time elapses after an alarm or event
started (point in time the alarm signal became
active).
When this is selected, enter the period for after the
alarm or event starts within the range of 1 to 3,600
seconds.
From Even End
This ends recording when the specified duration
has passed after the point in time the alarm or event
ends (point in time the alarm is cancelled).
Note
If the camera properties for alarm recording or
regular recording are different from the camera
properties for monitoring, the camera image will
stop updating for several seconds when recording
starts and stops. Be sure to confirm your settings
before operation.
Advertisement
Table of Contents
