Table of Contents
Advertisement
1
Click [Device] at the top of the Configuration window.
The Device Configuration screen appears.
2
Select the camera that will be the target for processing
from the [Device] tree.
3
Add the VMF package.
1
1 Select the [VMF] check box.
2 Click [Add], select whether to add a motion
package or object package from the Select Package
Type dialog box that appears, and click [OK].
The package is added.
4
Configure each item, and configure the VMF package.
A VMF package consists of a combination of up to
three filters (motion detection criteria), with advanced
settings for each filter, and up to six inactive areas.
Follow the procedure below to configure filters and
inactive areas.
66
Configuring Motion Detection Settings
2
1
8
4
2
3
5
6
7
For details on each of the items, refer to "Setting Items
of [VMD] Tab (VMF)" (page 67).
1 Select the [Enable] check box.
2 Select the package to configure.
3 Change the package name, as necessary.
4 Select how the filters are combined ([Sequential] or
[Parallel]).
Note
For sequential configurations, be sure to configure
two or more filters.
Caution
To switch between sequential and parallel, the
filter and inactive area must be turned off. When a
button is
click to set it to
(Off).
5 Set the filter name and filter type.
6 Click
button to
When the button is
(On), the criteria can be set.
7 Configure the criteria while checking the preview.
Repeat Steps 5 to 7 to configure the remaining
filters and inactive areas in the same way.
9
button for each
(On),
to set the
(On)
Advertisement
Table of Contents
