Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Options Parameter Defaults - Motorola RS507-IM2xxxxSTWR Product Reference Manual

5 - 2 RS507 Product Reference Guide

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several
bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Options Parameter Defaults

Table 5-1 lists defaults for user preferences parameters.
Scan the appropriate bar codes in this guide. These new values replace the standard default values in memory. To
recall the default parameter values, scan the
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 5-1
User Preferences
Motion Sensing Control
Proximity Sensing Control
Proximity Continuous
Proximity Continuous Enable
Good Scan indication delay Control
Set Default Parameter
Parameter Bar Code Scanning
Beep After Good Decode
Beeper Tone
Beeper Volume
Beeper Duration
Picklist Mode
Appendix A, Standard Default Parameters
Parameter
Beeper Tone on page
Set Default Parameter on page
for all user preferences, hosts, symbologies, and
Parameter
Number
Enabled
Enabled
Enabled
Disabled
600 ms
Set Defaults
ECh Enabled
38h Enabled
91h Medium
8Ch High
F1 74h Medium
F0h 92h Disabled Always
5-6. The Imager issues a fast
5-4.
Page
Default
Number
4-12
4-12
4-12
4-12
4-13
5-4
5-5
5-5
5-6
5-7
5-8
5-10