Finger Strap
Wearing the Imager - Cordless Adapter
Figure 1-6
Getting Started - Corded Configuration
In order to start using the Imager you must install the Corded Adapter.
Connect the Corded Adapter
To connect the Corded Adapter:
Align the Corded Adapter on top of the Imager.
1.
Support the bottom side of the Imager and push the Corded Adapter all the way into the Locking Slots of the
2.
Imager.
Firmly press the Corded Adapter into the Imager until a click is heard ensuring the Adapter Release Latch is
3.
fully engaged with the Imager.
Adapter Release Latch
Connect Corded Adapter
Figure 1-7
Remove the Corded Adapter
To remove the Corded Adapter:
Hold the Imager in one hand.
1.
Press the Adapter Release Latch.
2.
Pull up the Corded Adapter to release it from the Locking Slots of the Imager.
3.
Corded Adapter
Locking Slots
Getting Started
1 - 7