Table of Contents
Advertisement
Chapter 4 RS507 Update and Configuration
Introduction
This chapter covers the following topics:
•
Configuring the Imager
•
Imager Motion and Proximity Configuration
•
Debugging logger
•
Firmware upgrade
Configuring the Imager
Introduction
The Imager is a modular product used in several hardware configurations. Such configurations may include corded
or cordless connection to a terminal / mobile computer with manual or automatic triggering.
The Imager is provided with a default software configuration set in the factory. This software configuration can be
optimized by the customer to meet their specific operational requirements. Therefore, before using the Imager, it is
essential that the Imager be properly configured to harness its extensive capabilities and gain maximum efficiency.
There are several ways to configure the Imager. The best way is to set the parameters for each application allowing
the required degrees of freedom. In some cases it is recommended to allow the user to select between the various
operational modes or use cases, each with its own set of parameters.
Motorola mobile computers using the EMDK may utilize the SCAN and/or RSM APIs to configure the operation of
the Imager. Motorola terminals that cannot use the EMDK, may configure some operations of the Imager by
scanning special configuration bar codes (see
Motorola bar code scanners.
A selection of most configured Imager parameters can be set with the Remote Scanner Management Sample
(RSMSample) application installed on all Motorola mobile computers supporting the Imager. Some of the Imager
parameters can also be set by the Control Panel application.
Miscellaneous Imager Options on page
5-1) as done with many of
Hide quick links:
Advertisement
Table of Contents
