Scanning Sequence Examples; Errors While Scanning; User Preferences Parameter Defaults - Motorola MX101 Product Reference Manual

4 - 2 MX101 PRODUCT REFERENCE GUIDE

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under
a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Data Transmission Formats, require scanning several bar codes. See these
parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences Parameter Defaults

Table 4-1 lists defaults for user preferences parameters. To change any parameter value, scan the appropriate
bar code(s) provided in the User Preferences section beginning on
NOTE See
miscellaneous default parameters.
User Preferences Default Table
Table 4-1
User Preferences
Set Default Parameter
Parameter Bar Code Scanning
Lock Parameter Scanning
Unlock Parameter Scanning
Beep After Good Decode
Beeper Tone
Beeper Volume
Beeper Duration
Suppress Power-up Beeps
Trigger Modes
Decode Session Timeout
Timeout Between Decodes, Same Symbol
Timeout Between Decodes, Different Symbols
Motion Detect Range
Appendix A, Standard Default Parameters
Parameter
Beeper Tone on page
page 4-4.
for all user preferences, hosts, symbologies, and
Parameter
Default
Number
Restore Defaults
ECh Enable
F2h 22h Disable
F2h 23h Disable
38h Enable
91h Medium
8Ch High
F1h 74h Medium
F1h D1h Do not suppress
8Ah Presentation Mode
88h 9.9 Sec
89h 0.3 Sec
90h 0.2 Sec
F2h 3Bh Full
4-8. The scanner issues
Page
Number
4-4
4-5
4-6
4-6
4-7
4-8
4-9
4-10
4-10
4-11
4-11
4-12
4-12
4-13