Getting Started - Cordless Configuration; Charge The Battery; Install The Battery; Remove The Battery - Motorola RS507-IM2xxxxSTWR Product Reference Manual

1 - 6 RS507 Hands-Free Imager Product Reference Guide

Getting Started - Cordless Configuration

Charge the Battery

Before using the Imager, charge the battery. The SAC5070 8-Bay Battery Charger supports both standard and
extended capacity batteries.
To charge the Imager battery, refer to the SAC5070 8-Bay Battery Charger Quick Reference Guide, p/n
72-115989-01 available at:

Install the Battery

Align the battery on top of the Imager.
1.
Push the battery all the way into the Locking Slots of the Imager.
2.
Firmly press the battery into the Imager until a "click" is heard ensuring the Battery Release Latch is fully
3.
engaged with the Imager.
Battery Release Latch
Install the Battery
Figure 1-5

Remove the Battery

Hold the Imager in one hand.
1.
Press the Battery Release Latch.
2.
Pull up the battery to release it from the Locking Slots of the Imager.
3.

Wearing the Imager

Slide the Imager onto the index and middle fingers with the Scan Trigger next to the thumb.
1.
Tighten the Finger Strap.
2.
NOTE When using the Imager for the first time, press and release the Scan Trigger to enable the manual
www.motorola.com/enterprisemobility/manuals
Battery
Locking Slots
triggering mode (this operation disables the default auto triggering mode).
and search for 'SAC5070'.