Table of Contents
Advertisement
Chapter 4 User Preferences
Introduction
You can program the scanner to perform various functions, or activate different features. This chapter describes
each user preference feature and provides programming bar codes for selecting these features for the scanner.
The scanner ships with the settings shown in the
A, Standard Default Parameters
the requirements, programming is not necessary.
Set feature values by scanning single bar codes or short bar code sequences. The settings are stored in
non-volatile memory and are preserved even when you power down the scanner.
If not using a Synapse or USB cable, after hearing the power-up beeps, select a host type (see each host chapter
for specific host information). You only need to do this once, upon the first power-up when connecting to a new
host.
To return all features to their default values, see the
programming bar code menus, asterisks (
Scanning Sequence Examples
In most cases, you must only scan one bar code to set a parameter value. For example, to set the beeper tone to
high, scan the High Frequency (beeper tone) bar code under
warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as specifying Laser On Time or setting Data Transmission Formats, require scanning
several bar codes. See
descriptions of this procedure.
for all host device and miscellaneous scanner defaults). If the default values suit
*
) indicate default values.
*
*
High Frequency
Indicates Default
Laser On Time on page 4-6
User Preferences Default Table on page 4-2
Set Default Parameter on page
Feature/Option
Beeper Tone on page
and
Scan Data Transmission Format on page 13-5
(also see
Appendix
4-3. Throughout the
4-4. The scanner issues a fast
for
Advertisement
Table of Contents
