Customize The Imager; Changing From Triggered To Triggerless Configuration - Motorola RS507-IM2xxxxSTWR Product Reference Manual

1 - 16 RS507 Hands-Free Imager Product Reference Guide
When using the application on your mobile computer in "Pick List" mode, the Bright Center Dot can be positioned
anywhere on the symbol (see
the bottom examples can not be decoded.
Acceptable Aiming Options
Figure 1-17
The aiming pattern is smaller when the Imager is closer to the symbol and larger when it is farther from the symbol.
Scan symbols with smaller bars or elements (mil size) closer to the Imager and those with larger bars or elements
(mil size) farther from the Imager.
Hold the Imager between two and eleven inches from the bar code (depending on the bar code density).
1.
NOTE When a symbol is under transparent plastic or on a mobile computer screen, it is recommended to use a
tilt (pitch) or skew scan angle to minimize reflection.
Press the Scan trigger. The aiming pattern illuminates red indicating that the laser is on. One green flash of the
2.
Scan LED and a high beep indicates that a bar code was properly decoded.

Customize the Imager

Changing from Triggered to Triggerless Configuration

To change from Triggered to Triggerless configuration:
Remove the Comfort Pad (see
1.
Remove the Trigger Swivel Assembly (see
2.
Install the Triggerless Strap Holder (see
3.
Install the Comfort Pad (see
4.
Perform a cold boot (see
5.
Figure 1-15).The top examples in
0 1 2 3 4 5
0 1 2 3 4 5
Comfort Pad Replacement on page
Trigger Swivel Assembly Replacement on page
Triggerless Strap Holder Replacement on page
Comfort Pad Replacement on page
Cold Boot on page 1-17).
Figure 1-17 show acceptable aiming options, while
0 1 2 3 4 5
0 1 2 3 4 5
3-3).
3-3).
3-4).
3-6).